The Automated Fastener Inventory System, or “AFIS”, was an AFRL funded project aimed at greatly increasing fastener inventory control accuracy as well as automatically [...]
This 20′ pylon and positioner features a 1,500 lb load capacity with a 45 degree pitch axis and an allowable moment load of 2 inches horizontally and 18 inches vertically.
This pylon features a design specification of 3,000 lb capacity, shown being tested at 4,500 lbs. This pylon has 26 degrees of elevation travel and can cover that span in under 30 seconds [...]
This system includes a 20 foot pylon with an AZ/EL “top hat” positioner, plus the base includes pylon-side-shift, pylon-rotate, and pylon-tilt-down capability. One of the design [...]
This system replaced thousands of hand-drilled holes with a fully automated machine. It was designed specifically for the unique attributes of the C-130 cargo ramp. A pressure foot is [...]
This indoor system features a 20 foot pylon that retracts into the floor. The 3,000 pound capacity positioner has 0-45 degrees of EL travel and continuous AZ travel. This system also [...]
DSC built the antenna positioning system for this test system for the F-117A Nighthawk in a partnership with Skunkworks and SPC. It is designed to be deployable with the fleet. The system is a [...]
The “Full Scale Pole Model” (FSPM) is used to test the radar cross section (RCS) of the F-22 Raptor. All of the flight control surfaces and engine control surfaces are functional. DSC designed [...]
This system is used to test electromagnetic reflectivity and transmissivity of 4′ x 8′ loaded core or foam materials. It is used at the same facility as the core loading system. The [...]
This system is used to load cellular core material for use on stealth vehicles. This system makes 4′ x 8′ sheets from 0.3 to 12 inches thick. Cores can be taper loaded in the “T” [...]
Contact Us
We're not around right now. But you can send us an email and we'll get back to you, asap.
info@deltasigmacompany.com
